Effect of Er: YAG and burs on coronal dentin bond strength stability

To evaluate the immediate and aged bond strength and interfacial nanolaekage of different adhesives and protocols on dental elements prepared with diamond burs and Er:YAG laser. MATERIALS AND METHODS: Forty molar crowns were flattened and a standardized smear layer was created. Teeth were divided into two main groups according to the dentin cutting technique: 1. Er:YAG laser for 30 s at 30 Hz repetition rate, 250 mJ energy per pulse, and water spray irrigation set at level 8; and 2. diamond bur. Each group was then divided into subgroups according to the adhesive protocol: SG1: dentin etching for 15 s followed by universal adhesive application (All Bond Universal, Bisco); SG2: universal adhesive application (All Bond Universal); SG3: two-step self-etch adhesive application (Clearfil SE Bond 2, Kuraray Noritake); SG4: etching followed by 3-step etch-and-rinse adhesive application (Optibond FL, Kerr). After curing the adhesives, resin composite buildups of 4 mm were made and specimens were sectioned to obtain 1-mm-thick sticks in accordance with the μTBS test technique. Sticks were stressed to failure at baseline and after 6 months of storage in artificial saliva. Three teeth per group were prepared for nanoleakage interfacial analyses. Data were statistically analyzed with three-way ANOVA and Tukey's post-hoc test (p < 0.05). RESULTS: A significant difference in bond strengths was found for treatment, aging, and adhesive protocol. Nanoleakage analysis showed higher marginal infiltration in Er:YAG-treated groups both at baseline and after aging. CONCLUSIONS: Surfaces prepared with diamond burs presented higher bond strengths than did those prepared with Er:YAG laser. Adhesive protocols and aging could influence the adhesive-dentin interface. Further studies are necessary to validate the results obtained.